Page 5 sur 26
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
3. Serial and Ethernet Configuration
Your MULTI4 marking equipment can communicate by sending orders using the RS232 serial port or the optional
Ethernet port.
Both port settings can be configured using the communication window (see User Guide)
Your M4 Inline marking equipment embedded an Ethernet card allowing to connect the marking machine to the
client internal net (using straight cable) or directly to a PC (using crossed cable). Ideally, connect your control box on
your company network (switch, hub …). For a direct connection to a Computer, you should prefer use RS232
connection way.
Parameters and configuration of your Network and control box must be done by your Network administrator.
When this option is installed, and a cable is connected, the M4 Inline tries immediately to establish a communication
with the net.
The TCP communication port is 6120 port.
Client net Connection
A DHCP server is available on the net, MULTI4 includes a DHCP client module, and the MULTI4 IP address is
automatically attributed by the server.
Direct PC connection :
If the PC includes a DHCP server, it works exactly the same way as previously.
The RS232 cable should be a straight cable.
To Next Page
Loading...
