Page 7 sur 26
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
4.3.Serial Number command - C
It is possible to give a value to a serial number with command C followed by the serial number name, then the
character = then the desired value.
Example:give the value 123 to a serial number NUM
[STX]CNUM=123[CR][ETX]
4.4.Marking parameters command - H
Command H allows to setup marking parameters of the current file on the control box.
The parameters values are :
M : mirror mode m. ‘0’ no mirror, ‘1’ horizontal mirror, ‘2’ vertical mirror
Z : Zero appearance. ‘0’ for crossed zero, ‘1’ non crossed zero
V : marking speed. From ‘1’ to ‘5’
A : '0'
DDDD : '0000’
ZZZZ : ‘0000’
ZZZZ : ‘0000’
The frame has the following form:
[STX]HMZVADDDDZZZZZZZZ [CR][ETX]
Example: No mirror mode, slashed zero, speed 2:
[STX]H0020000000000000[CR][ETX]
Example: No mirror mode, with slashed zero, speed 5 :
[STX]H0052000000000000[CR][ETX]
4.5.IDI command - I
To set IDI file parameters, send the I command with IDI parameters.
Value 0 to disable IDI, 1 to enable IDI flat mode and 2 to enable curved mode.
Example: IDI flat mode for the current file:
[STX]I1[CR][ETX]
The serial number NUM has to be programmed in the opened file on the controller.
To Next Page
Loading...
