Page 10 sur 26
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
4.8.Start Marking command - D
Marking is ordered by the command D.
Example : [STX]D[CR][ETX]
To get the information frames at the end of marking, the return must be activated by command R followed by
character 1 (or 0 to deactivate this function)
Example [STX]R1[CR][ETX]
In this case the following frames will be sent by the marking machine:
When the last marking impact is done, the controller returns the "end of marking" frame :
[STX]Marking End[ETX]
When the marking cycle is finished, the controller returns the "end of cycle" frame :
[STX]Cycle End[ETX]
4.9.Pause and stop - Q
Marking can be forced to pause mode by command Q
Example : [STX]Q[CR][ETX]
The pause will stay as long as no other command is sent.
By sending the marking frame the marking will go on
Sending once again the pause command Q will stop the marking and the head will return to origin position and
cancel marking.
4.10. Last Error - E
You can recover the last error Control box error code by sending command E:
[STX]E[CR][ETX]
In that case the machine return the last error code RR (see error code)
[STX]ERR[ETX]
Example : No error
[STX]E00ETX]
The last error can be erased sending K command:
[STX]K[CR][ETX]
To Next Page
Loading...
