Page 8 sur 26
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
4.6.New File command - N
To create a new marking file, send the N command.
Example : [STX]N[CR][ETX]
4.7.Marking line command - M
You can send a complete marking line with frame M and the following parameters:
XXXXX : position X in tenth of mm , from ‘-9999’ to ‘+9999’
YYYYY : position Y in tenth of mm , from ‘-9999’ to ‘+9999’
HHH : height in tenth of mm , from ‘005’ to ‘999’
CCC : compression, from ’050 ‘to ‘200’
RRRRR : Radius for circular marking, in tenth of mm, from ‘-9999’ to ‘+9999’
AAAA : angle in tenth of degrees from ‘0000’ to ‘3600’
F : Marking depth from ‘1’ to‘5’
P : font ‘0’ or ‘1’
M : Matrix from ‘1’ to ‘3’
VVV : spacing between the points for matrix 3, from ‘000’to ‘255’
E : spacing between the characters from ‘0’ to ‘9’
I : italic from ‘0’ to ‘9’
… : text to be marked ; length under 255 characters (text field)
The frame has the following structure:
[STX]MXXXXXYYYYYHHHCCCRRRRRAAAAFPMVVVEI…[CR][ETX]
Example : line containing “MYTEXT” in position x=10 & y=20, height 10 mm, compression 100, no radius nor angle,
marking depth 2, font OCR, matrix 2, normal spacing, normal italic:
[STX]M+0100+0200100100+0000000020200055MYTEXT[CR][ETX]
The line is added at the end of the opened marking file on the control box.
4.7.1. Logo
To insert a logo in a marking line, use the syntax [L=logoname.lgo] in the text field.
Example: Insert the logo named LOGO.lgo in the text line just after the text “MYTEXT”
[STX]M+0100+0200100100+0000000020200055MYTEXT[L=LOGO.lgo][CR][ETX]
To Next Page
Loading...
