Page 9 of 22
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail: info@technomark-marking.com
6. Preventive maintenance: Maintenance timetable.
6.1.General
The control panel on the welcome screen of the control unit has a maintenance indicator:
Maintenance indicator: The LED turns red when a maintenance operation is required.
For more information, refer to the ‘Maintenance’ chapter in the Inline-user-maintenance-
software)
The timetable for the operations required for the preventive maintenance of your marking device is shown for
illustrative purposes only. Carrying out this preventive maintenance will extend the life of your marking machine.
This timetable has been drawn up according to the following reference settings:
2,000 markings per day, based on 24h worked per day, 3x8 (complete cycle of 43s).
Marking of 10 characters on two lines, height of characters 4mm, and 5x7 matrix.
Position of lines in X=10 / Y=10 and 15 mm
Medium marking force, level 3/6 + standard marking speed, level 3/5.
The other settings are standard.
Average results (depends on the characters marked): Marking time of 9s / 152 impacts per marking / 0.11m
displacement on the X axis and 0.10m displacement on the Y axis.
In the case of more intensive use (greater force/speed/number of impacts) or a difficult environment (chips of materials,
considerable amount of fluid and dust), the preventive maintenance frequencies listed below should be shortened, to
ensure that your device continues to function correctly.
In the event of intensive use, the active part of the machine (coil body) may reach a temperature of
over 70°C. Do not conduct any operations on this element without suitable protection and/or allow
this part to cool before handling it.
The maintenance and upkeep operations must be conducted with the machine
SWITCHED OFF. The power cable must be disconnected.
The knurled nut on the striker unit must be tightened/loosened manually. Never use
tools, as this could cause serious damage. The quality of your machine will be
impaired.
To Next Page
Loading...
