Page 3 of 22
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail: info@technomark-marking.com
1. Introduction.
TECHNOMARK reserves the right to change the information and specifications contained in this manual without prior
notice. You should consult TECHNOMARK to learn of any changes that may have been made.
Under no circumstances may TECHNOMARK be held responsible for any direct or indirect incident related to damages,
even if exceptional, including, but not limited to, financial losses related to the use of information contained in this
manual. This clause also applies in cases where TECHNOMARK has been informed and/or had prior knowledge of
possible risks associated with the use of the equipment.
The TECHNOMARK guarantee of the equipment it manufactures is defined in its terms and conditions. Unless
specifically stated otherwise on our acknowledgement of order receipt, our equipment is guaranteed for 1 (ONE) year
from the delivery date of the equipment. This guarantee consists in our replacement, free of charge, of any defective
parts, except with regard to externally supplied sub-assemblies, in which case the supplier's warranty is applied. This
warranty does not cover defects resulting from normal wear of the products, incorrect use, maintenance not
performed in accordance with standard trade practices, inadequate storage conditions, an inappropriate product
environment, excessive use of the equipment or failure to follow the instructions for use and/or connection. Under
no circumstances will any repair work covered by the guarantee that causes a loss of time or profit result in an
extension of the said guarantee.
The following are excluded from the cover:
- Stylus
- Spring
- Stylus guide
- Core
- The outer part of the cable between the control unit and the marking head or an accessory.
The information contained in this manual is confidential and remains the property of the TECHNOMARK company.
2. Manuals
The information that is required throughout your machine's lifespan is available in the following manuals:
M4 inline Installation Manual: Contains information on unpacking and installing your equipment.
M4 inline Software Manual: Contains the necessary information for configuring and using your marking
machine.
Interfacing instructions for M4 inline: Contains the necessary information for establishing communication with
your equipment (RS232, Ethernet, 16-way).
M4 inline Maintenance Manual: Contains information about servicing your machine.
Information essential for the safety of the user.
Information essential for the safety of the machine.
does not indicate a malfunction or fault.Additional information.Complementary information
To Next Page
Loading...
