Technomark M4 inline - Variable Configuration

Page 17 of 22
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Model from 14/04/2016
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail: info@technomark-marking.com
 Error code
 1st level
troubleshooting
 Remedial action
The impact unit connector has
been damaged.
Check the impact unit
connector and restart the
control unit.
The marking head cable has
been damaged.
Check the condition of the
marking head cable and restart
the control unit.
If the problem persists, contact
the After-Sales Customer
Service Team.
Error code 9: Open circuit.
The impact unit cable has been
cut or damaged.
Check the condition of the
impact unit cable and restart
the control unit.
The impact unit connector has
been damaged or is not
properly connected.
Check the impact unit
connector and restart the
control unit.
The marking head cable has
been cut or damaged.
Check the condition of the
marking head cable and restart
the control unit.
Contact the After-Sales
Customer Service Team.
Error code 10: Weak current.
The impact unit cable has been
damaged.
Check the condition of the
impact unit cable and restart
the control unit.
The impact unit connector has
been damaged or is not
properly connected.
Check the impact unit
connector and restart the
control unit.
Contact the After-Sales
Customer Service Team.
Error code 11: No impact.
No measuring impact.
Check stylus/part distance.
Contact the After-Sales
Customer Service Team.