43
English
6. Operation
6.4 Electronic Program Guide
➋
Timer
This sub menu allows you to set the on/off time of your receiver.
1. This submenu allows you to set on/off times of your receiver. To display the timer menu,
press the RED button while in the guide menu. <Figure 6.4.2>
2. Press OK to select a timer’s parameter.
3. Press to change the parameter.
▪ Timer No: Select the timer that you want to modify. (1- 32 )
▪ State: Select the timer frequency. (off/once/daily/Mon~Fri/weekly)
▪ Date: Press OK to display a Calendar pop-up; Select a date
▪ Start Time: Input the time for your receiver power-on; use the NUMERIC buttons
▪ End Time: Input the time for your receiver power-off; use the NUMERIC buttons
▪ Channel: Press OK to display a Channel list pop-up; Select a channel
▪ File Name: Press OK and enter file name using keypad.
▪ Record: Set the record mode (ON/OFF)by using the left and right arrow button.
▪ Power Off: Select Power Off should you wish the receiver to turn to standby
after recording has finished.
To Next Page
Loading...