TECMOR PG 35 three-phase - Safety Devices; Magneto-thermic Switch and Differential; Machine Body Grounding; Emergency Stop Button

12
12 Cleaning
In case of cleaning do not use any solvents which could damage the machine.
Clean and lubricate carefully all the holes and the sliding parts.
13 Machine keeping
• In case the machine does not work for a long time, it is better to grease or lubricate the unpainted
parts of the machine.
• Moreover, grease or lubricate all the pins, the bending bushes and the toolings.
• Unplug the power cable.
• If the machine is placed outdoors, cover it completely with waterproof material.
• The standard life of the machine used according to the instructions of this handbook and to a correct
periodical maintenance is about 20.000/30.000 working hours.
14 Demolition and disposal
There is no particular caution before breaking up the machine, because it does not contain dangerous
materials. In case of breaking up, it is necessary to separate three different materials: oil contained in
the reduction gear, copper of the motor/electric system and metal parts.
15 Safety instructions
a) It is forbidden to repair, set, service or clean any moving part.
b) The safety guards and devices in the machine must not be removed or modified.
c) Dimensions and shapes to be bent or cut cannot be foreseen and, for this reason, the worker must
produce some supports if necessary to avoid any danger for the worker himself.
16 Safety devices
The machine is provided with the following safety devices:
16.1 Magneto-thermic switch and differential.
16.2 Grounding of the machine-body.
16.3 Button for emergency-stop:
The machine is equipped with a mushroom-button as emergency-stop. Through this control the
machine power is immediately off.
16.4 Controls for machine starting:
All the controls are produced with purpose protections according to their use in order to grant a
protection IP 54, according to the EC legislation, and they cannot start accidentally.
16.5 Man-driven control foot-pedal:
The machine starting control is given by the man-driven electrical foot-pedal: the bending operation
starts only if the pedal is kept pushed.
Whenever the pedal is released, the machine stops immediately.
16.6 Guards for gear parts:
The gear parts are arranged in the machine frame and they are protected by a screwed-on door which
can be opened only by means of a wrench: in this way the contact is impossible.
The removal of this door is allowed for maintenance purposes only and therefore the power supply
must be disconnected.