TECMOR PG 35 three-phase

Need help?

Do you have a question about the TECMOR PG 35 three-phase and is the answer not in the manual?

Summary

General Features of the Machine

Installation and Connection

Supply Net Connection

Details voltage requirements and the necessity of a differential switch (< 30 mA).

Grounding System

Emphasizes compulsory grounding for safety and specifies resistance requirements.

Use of the Machine

Use of the Standard Machine

Describes the operation and controls for standard bending machines.

General Controls of the Standard Machine

Identifies and explains the primary controls on the standard machine.

Starting and Working (Standard Machine)

Details the step-by-step procedure for starting and operating the machine.

How to Bend a Piece

Explains bending operations using square, pin/bush, and special stirrup tools.

How to Cut a Piece

Provides instructions for cutting operations on combined machines.

Use of Machines with Panel 9 x9 and Speed Variator

Covers operation using the 9x9 panel and speed variator for bending sequences.

General Controls of the Machine (Panel 9 x9)

Starting and Working (Panel 9 x9)

Limitations on the Use

Minimum Mandrel Diameter

Maximum Working Performance

Mono-phase Machine Performance

Malfunctioning, Failure and Breakdown

Machine Cannot Bend Maximum Diameters

Troubleshooting steps for issues with bending maximum diameters.

Machine Stopped and Wont Start

Troubleshooting for machines that stop and fail to restart.

Disc Turns Without Stopping

Diagnosing why the disc continues to turn past the limit-switch signal.

Maintenance, Inspections and Checks

Oil Level Check

Blades Replacement

Safety Instructions

Prohibited Actions

Lists actions forbidden during repair, setup, service, cleaning, and modification.

Guards and Devices

Mandates that safety guards and devices must not be removed or modified.

Safety Devices

Magneto-thermic Switch and Differential

Machine Body Grounding

Emergency Stop Button

Describes the mushroom-button emergency stop for immediate power cut-off.

Machine Starting Controls

Man-Driven Foot Pedal

Guards for Gear Parts

Moving Interlocking Guards

Details safety guards for the moving bending area with interlock features.

Fixed Guard for Cutting Area

Residual Risks

Mechanical Risks

Electrical Risk

After-Sales Service During Guarantee

Guarantee Conditions