www.tecnaonline.com - info@tecnaonline.com
ENGLISH
PAR DESCRIPTION
2.4 BASIC SAFETY INSTRUCTIONS
9
/
44
REV
0.0
SAFETY
2
2.4.1
GENERAL INSTRUCTIONS
FOR TRANSPORTATION
•
Follow the transportation instructions on the packaging.
FOR MOUNTING AND REMOVING
•
Follow the instructions of the manufacturer when using mechanical and hydraulic changing
equipment.
•
Follow the support frame-specific instructions and the safety instructions of the support frame
manufacturer when mounting without changing equipment.
•
Connect the connections to the support frame at zero pressure before you mount the hydraulic
breaker.
•
Only use a proper tool for that.
•
Lay the lines such that they are not damaged.
•
Ensure before commissioning that all the seals and fasteners at the ends are fit correctly and are
undamaged such that liquids and foreign bodies cannot enter into the hydraulic breaker.
•
Pay attention to utmost cleanliness when mounting so as to avoid impurities from entering the
hydraulic lines, which could lead to wear and malfunctions in the hydraulic breaker and support frame.
FOR COMMISSIONING
•
Ensure that all the hydraulic connections are covered or closed. Operate a fully installed hydraulic
breaker only.
FOR CLEANING
•
Close all the openings using suitable protective equipment such that the cleaning agents do not
enter the system.
•
Use a suitable cleaning device for cleaning and follow the instructions regarding the cleaning device.
•
Wear protective clothing (e.g. protecting goggles, face mask among other things) when dealing
with compressed air or pressurised water.
FOR MAINTENANCE
•
Carry out the prescribed maintenance work at intervals specified in the operating manual.
•
Ensure that no line links, connections and components come off till the system is under pressure.
•
Do not search for leakages with bare hands; the pressure medium can come out with high pressure
which can cause injuries.
FOR DISPOSAL
•
Dispose of the hydraulic breaker as per the country-specific regulations.
•
Dispose of the pressure medium or grease as per the country-specific regulations.
•
Dispose of the pressure medium residues or grease in accordance with the valid safety data
sheets for pressure mediums and grease.
•
Consult TECNA or your dealer when using biodegradable mediums.
OPERATING MANUAL - Hydraulic breakers T series
To Next Page
Loading...
