TECNA T Series - Maintenance and Inspection Plan

www.tecnaonline.com - info@tecnaonline.com
ENGLISH
PAR DESCRIZIONE
10.2 INSPECTION AND MAINTENANCE
WEAR MAINTENANCE
All movable parts are subject to wear, which depends on the operating time, load factor and the
operating conditions. There are a few recommendations since the operating conditions are varied.
Period Operating hours
Abbreviation in the maintenance
and inspection plan
Semi-diurnal 4 1
Daily 8 2
Once in two weeks 80 3
Every 6 months Approximately 1000 4
Every 12 months Approximately more than 1500 5
10.2.4
MAINTENANCE AND INSPECTION PLAN
You must reduce the maintenance interval in case of major stress on the hydraulic breaker or
duetoenvironmentalinuences(e.g.lotoffdustformation,highhumidity).
Follow the maintenance and inspection instructions of the support frame; see the
operating manual of the support frame.
OPERATING MANUAL - Hydraulic breakers T series
35
/
44
REV 0.0
MAINTENANCE (DIN EN 31051)
10