Tecnoalarm Evolution EV 10-50 - Page 28

EV 10-50
28
Wireless hybrid  arm sy em
Wireless hybrid  arm sy em
The selective arming and disarming modes allow the user to choose which programs to arm or disarm.
The arming and disarming of the programs is carried out in three phases: entering the code, selecting the programs and pressing
the command.
Selective arming Selective disarming
3-4.2 - General arming and disarming (direct)
The general arming and disarming modes, arm and disarm all the programs associated with the code at the same time, with a
single operation.Arming and disarming are performed in two phases: entering the code and command.The function can be enabled
or disabled from Menu:
11 Codes > 3 Master code > 4 Attributes > 7 Dis. direct.
General arming (direct) General disarming (direct)
1 - Enter the Code
2 - Select the programs
3 - Press the command
1 - Enter the Code
2 - Select the programs
3 - Press the command
1 - Enter the Code
2 - Press the command
1 - Enter the Code
2 - Press the command
3-4.1 - Selective arming and disarming
1 Enter the Code
Enter the code followed by the YES key, if you make a mistake while entering the code, press EXIT and repeat the
code entry from the beginning.
2 Select the programs
Press the command keys P1 ... P6 or the number keys 1..8 relating to the programs you want to arm or disarm.
If you make a mistake, press the key again, each time the key is changed from OFF to ON and vice versa.
3 Press the command
During arming, the YES key interrupts the selection phase and activates the programs.If you don' t press YES the
programs activate anyway after 15sec.When disarming, the YES key instantly deactivates the selected programs. If
you don't press YES , the programs are deactivated after 5sec.
1 Enter the Code
Enter the code followed by the YES key, if you make a mistake while entering the code, press EXIT and repeat the
code entry from the beginning.
2 Press the command
To arm the programs, press the YES key.
To disarm the programs, press the NO key.
11:02 System ok
End with YES
- ACCESS -
Master
Arming
Program 1
Arming
Control panel ok
11:02 System ok
11:02 System ok
End with YES
- ACCESS -
Master
Disarming
Program 1
11:02 System ok
11:02 System ok
End with YES
- ACCESS -
Master
Arming
Control panel ok
11:02 System ok
11:02 System ok
End with YES
- ACCESS -
Master
11:02 System ok
3-4 - Management by console