EV 10-50
6
Wireless hybrid arm sy em
Wireless hybrid arm sy em
1-5 - Level 2 Standard and Privileged users
The control panel can store and manage user codes, for each of them it is possible to defi ne a customised functional profi le.
The user with a code, can arm/disarm the system operating programs assigned to his/her code and activate or deactivate the
remote controls.The functionality of the user codes is defi ned and supervised by the user with the Master code.
Operations that Standard users can perform:
Management functions
The management functions illustrated are of a general nature, the actual functionality of the various User codes depends on the
programming of the functionality given to each individual code.
• Activation/deactivation of all remote controls.
• Thermostat management.
• Arming/disarming of the operating programs assigned to the code.
• Partial disarming of System programs (if enabled).
• Viewing of the event history memory.
• Clearing the control panel event memory.
• Silencing (blocking telephone calls in progress).
Standard user programming functions
Standard user codes cannot access the programming menus.
Privileged user programming functions
The Master user can switch the user codes from Standard status to Privileged status, associating the "Privileged" attribute to them.
The privileged user codes can access some programming menus.
• Telephone Menu.
• Isolation Menu
• Options Menu.
• Thermostats Menu.
1-4 - Level 2 Master user
The Master user level allows the control and programming of all the functions of the control panel, the management of home
automation functions, thermostats and the arming/disarming of all the System's operating programs.
To access the master level functions, the code must be entered; the code pre-set in the factory is as follows:12345.
The factory code can be changed by the installer, who in this case will supply the new code to the system operator.
Operations that can be performed by the Master user:
Management functions
• Activation/deactivation
of remote control.
• Management of Thermostats
• Arming/disarming of all operating programs.
• Partial disarming of programs.
• Viewing of the event history memory.
• Clearing the control panel event memory.
• Silencing (blocking telephone calls in progress).
Programming functions
• Changing the System date and time.
• Defi nition of the zones to which the chime function is associated (Chime - zone opening signalling).
• Defi nition of the operating parameters of the System's programs: zones belonging to the program, programming of input 1 and
2 delay times, exit delay, delay confi rmation of disarming .
• Enabling or disabling the operation of the time programmers, defi ning the access time slots in which other users can access
the site protected by the System.
• Customisation of the operating parameters of the System telephone section, made up of the GSM and IP telecommunication
carriers.For them it is possible to program: the telephone numbers and/or IP addresses used by the communicators to contact
and notify the system's functional and alarm events, for making test calls and Call Back.
• Programming of the Master access code and its functions.
• Programming of User access codes and their functions.
• Programming of key operating parameters and storage (acquisition) of new keys.
• Programming of the operating parameters of the wireless keys.
• Adjustment of the audio volume of the consoles and enabling the specifi c or general reproduction of voice messages.
• The Master user can isolate the Protection Zones.Isolation is an action that places the zone completely out of service or more
generally the detection device that belongs to the Zone.
• Access to the Test menu with which to perform functional tests and check the System fi rmware versions.
• Access to the Options menu.
• Access to the Thermostats menu.
To Next Page
Loading...
