4-12
KEYS (8) Description
RUN
RUN Inverter in Local Mode
STOP
STOP Inverter
▲ Parameter navigation Up, Increase parameter or reference value
▼ Parameter navigation down, decrease parameter or reference value
FWD/REV
(Standard Type)
Used to switch between Forward and Reverse direction
LOC/REM
(Enhanced Type)
Used to switch between Local Mode and Remote Mode
REMOTE Mode: Set by parameters, controlled by control circuit terminals,
communication or other ways.
LOCAL Mode: Controlled by operator.
It displays REMOTE Mode at power-up. Users can switch between LOCAL and
REMOTE Mode if they press LOC/ REM keys when the inverter stops. Parameter
of 23-41 can determine if LOC/REM keys are enabled or not.
DSP/FUN
Used to scroll to next screen
Frequency screen Function selectionMonitor parameter
◄ / RESET
Selects active seven segment digit for editing with the ▲▼ keys
Used to reset fault condition.
READ / ENTER
Used to read and save the value of the active parameter
Auto-Repeat Keys
Holding the ▲UP or ▼DOWN key for a longer period of time will initiate the auto-repeat function resulting in the
value of the selected digit to automatically increase or decrease.
To Next Page
Loading...
