TECO A510s Series - Page 103

4-13
4.2.2 Keypad Menu Structure
Main Menu
The A510S inverter main menu consists of two main groups (modes). The DSP/FUN key is used to
switch between the monitor mode and the parameter group mode.
Mode Description
Monitor Mode
View inverter status, signals and fault data.
Parameter Group Mode Access to available parameter groups.
All the available parameter groups are listed in the Parameter Group Mode use the up and down keys
to select a group and press Read/Enter key to access its parameters.
Fig. 4.2.2.1 Parameter Group Structure
Notes:
- Always perform an auto-tune on the motor before operating the inverter in vector control (sensorless vector or
flux vector). Auto-tuning mode will not be displayed when the inverter is running or when a fault is active.
- To scroll through the available modes, parameter groups or parameter list press and hold the up or down key.