TECO A510s Series - Page 105

4-15
Programming Mode
In programming mode inverter parameters can be read or changed. See Fig 4.2.2.3 for keypad
navigation.
Power ON
DSP
FUN
READ
ENTER
READ
ENTER
READ
ENTER
READ
ENTER
To parameters
Monitor
Freq Ref
12-17=000.00Hz
12-18=0000.0A
12-16=005.00Hz
Control Method
Edit 00-00
0V/F
(0~4)
<0>
Motor Direction
0Forward
(0~1)
<0>
Run Source
0Digital Op
(0~4)
<1>
DSP
FUN
DSP
FUN
DSP
FUN
READ
ENTER
DSP
FUN
READ
ENTER
DSP
FUN
Edit 00-01
Edit 00-02
DSP
FUN
DSP
FUN
DSP
FUN
Group
01 V/F Pattern
02 Motor Parameter
00 Basic Func.
Group
02 Motor Parameter
00 Basic Fun.
01 V/F Pattern
Group
00 Basic Fun.
01 V/F Pattern
02 Motor Parameter
PARA 00
-00 Control Method
-01 Motor Direction
-02 Run Source
PARA 00
-00 Control Method
-01 Motor Direction
-02 Run Source
PARA 00
-00 Control Method
-01 Motor Direction
-02 Run Source
Parameter Group
Selection Mode
Parameter
Group Mode
Parameter
Edit Mode
DSP
FUN
Press ▼ or ▲
key to edit
parameter
value, and
press
READ/ENTER
key to save
the change.
Fig 4.2.2.3 Programming Mode
Notes:
- The parameters values can be changed from the Edit screen with the up, down and < / RESET shift key.
- To save a parameter press the READ/ENTER key.
- Refer to section 4.4 for parameter details.
- Press the ▲ (up) or ▼ (down) key to scroll parameter groups or parameter list.