TECO A510s Series - Page 106

4-16
Auto-tuning Mode
In the auto-tuning mode motor parameters can be calculated and set automatically based on the
selected control mode. See Fig 4.2.2.4 for keypad navigation.
Tune Mode Sel
READ
ENTER
Motor Rated Power
0 Rota tion al
(0 ~ 2)
< 0 >
5.50 KW
(0.00 – 600.00)
< 5.50>
Edit 17-00
00 0.00 Hz-00 0.0A
Auto-tuning Run
(Press Run Key)
0.0Hz – 0.0A
Autotuning
Aborte d
>>>>>>>>>>>>>>>
00 06.8 A
(00 00 .9~00 09 .2)
< 00 06.8 >
Motor Sel
Autotuning
48.0Hz – 14.0A
Autotuning
Successful
>>>>>>>>>>>>>>>>>>>>>>>
48.0Hz – 14 .0A
(Rotational)
>>>>>>>>>>>>>>>
Motor Data Error
ATE01
Uncompleted
>>>>>>>>>>>>>>>
Edit 17-01
Edit 17-02
DSP
FUN
READ
ENTER
DSP
FUN
READ
ENTER
DSP
FUN
READ
ENTER
DSP
FUN
Edit 17-10
Edit
Edit
Edit Ed it
1 En ab le
(0~1)
<0>
Autotuning ?
Edit
DSP
FUN
DSP
FUN
READ
ENTER
-01 Tune Mode Sel
-02 Motor Rate d Power
-03 Motor Rate d Curr.
PARA 17
-01 Tune Mode Sel
-02 Motor Rated Power
-03 Motor Rated Curr.
PARA 17
-01 Tune Mode Sel
-02 Motor Ra ted Power
-03 Motor Ra ted Curr.
PARA 17
-08 Mtr No-Load Volt
-10 Auto-tuning Run
-11 Auto-tuning Err
PARA 17
Group
17 Au to-tu ning
18 Slip Compen
19 Tr aver se Fun c.
Press ▲ or ▼ key to change the value.
Warning: Do not use “0”, Rotation
Auto-tune, when load is coupled with
the motor.
*1HP = 0.746KW
STOP
RUN
Tuning
successful
Tuning
fault
READ
ENTER
DSP
FUN
Fig 4.2.2.4 Auto-tuning Mode
Notes:
- Set correct motor parameters by referring to motor nameplate.
- Refer to section 4.4 for parameter details.