4-2
SEQ
LED ON when RUN command is from the external control terminals or from serial
communication
REF
LED ON when Frequency Reference command is from the external control terminals
or from serial communication
KEYS (8) Description
RUN
RUN Inverter in Local Mode
STOP
STOP Inverter
▲ Parameter navigation Up, Increase parameter or reference value
▼ Parameter navigation down, decrease parameter or reference value
FWD/REV
(Standard Type)
Used to switch between Forward and Reverse direction
LOC/REM
(Enhanced Type)
Used to switch between Local Mode and Remote Mode
REMOTE Mode: Set by parameters, controlled by control circuit terminals,
communication or other ways.
LOCAL Mode: Controlled by operator.
It displays REMOTE Mode at power-up. Users can switch between LOCAL and
REMOTE Mode if they press LOC/ REM keys when the inverter stops. Parameter
of 11-79 can determine if LOC/REM keys are enabled or not.
DSP/FUN
Used to scroll to next screen
Frequency screen Function selectionMonitor parameter
◄ / RESET
Selects active seven segment digit for editing with the ▲▼ keys
Used to reset fault condition.
READ / ENTER
Used to read and save the value of the active parameter
Auto-Repeat Keys
Holding the ▲UP or ▼DOWN key for a longer period of time will initiate the auto-repeat function resulting in the
value of the selected digit to automatically increase or decrease.
To Next Page
Loading...
