4-3
4.1.2 Seven Segment Display Description
Actual LED Display Actual LED Display Actual LED Display Actual LED Display
0
A
L
Y
1
B
n
-
2
C
o
°
3
D
P _
4
E
q
.
5
F
r
6
G
S
7
H
t
8
I
u
9
J
V
Display output frequency Frequency Reference Set Frequency Reference
LED lights on LED flashes Flashing digit
At power-up, the display will show the frequency reference setting and all LEDs are flashing. Press the
▲ (UP) or ▼ (DOWN) key to enter the frequency reference edit mode, use the ◄/RESET key to select
which digit to edit (flashing). Use the ▲ (UP) or ▼ (DOWN) key to modify the value and press the
READ / ENTER key to save the frequency reference and switch back to the frequency reference
display mode.
During run operation, the display will show the output frequency.
Note: When in edit mode and the READ / ENTER is not pressed within 5 sec, the inverter will switch back to
the frequency reference display mode.
To Next Page
Loading...
