TECO F510 series - Maintenance, Inspection and Replacement; Disposal of the Inverter

3
start automatically after power is restored.
 Make sure it is safe to operate the inverter and motor before performing a rotational auto-
tune.
 Do not touch inverter terminals when energized even if inverter has stopped,
otherwise electric shock may result.
 Do not check signals on circuit boards while the inverter is running.
After the power is turned off, the cooling fan may continue to run for some time.
Caution
 Do not touch heat-generating components such as heat sinks and braking resistors.
 Carefully check the performance of motor or machine before operating at high speed,
otherwise Injury may result.
 Note the parameter settings related to the braking unit when applicable.
 Do not use the inverter braking function for mechanical holding, otherwise injury may
result.
Do not check signals on circuit boards while the inverter is running.
1.6 Maintenance, Inspection and Replacement
Warning
 Wait a minimum of five minutes after power has been turned OFF before starting an
inspection. Also confirm that the charge light is OFF and that the DC bus voltage has
dropped below 25Vdc.
 Never touch high voltage terminals in the inverter.
 Make sure power to the inverter is disconnected before disassembling the inverter.
 Only authorized personnel should perform maintenance, inspection, and replacement
operations. (Take off metal jewelry such as watches and rings and use insulated tools.)
Caution
 The Inverter can be used in an environment with a temperature range from 14°
~104(140) °F (-10~+40(60)°C) and relative humidity of 95% non-condensing.
 The inverter must be operated in a dust, gas, mist and moisture free environment.
1.7 Disposal of the Inverter
Caution
 Please dispose of this unit with care as an industrial waste and according to your
required local regulations.
 The capacitors of inverter main circuit and printed circuit board are considered as
hazardous waste and must not be burned.
 The Plastic enclosure and parts of the inverter such as the top cover board will
release harmful gases if burned.
Equipment containing electrical components may not be disposed of together with
domestic waste. It must be separately collected with electrical and electronic waste
according to local and currently valid legislation.
1.8 Guaranteed liability exemption
 Loss of opportunity caused by the company's products, damage to customers of your
company or your company, damage to non-company products, or compensation for
other businesses, whether within the warranty period or not, is not covered by the
company.