Chapter 3 Program Tools 20
Connecting the Software
Remove the plastic connector cover from SG2 using a flathead screwdriver as shown in the figure below. Insert the
plastic connector end of the programming cable into the SG2 smart relay as shown in the figure below. Connect the
opposite end of the cable to an RS232C serial port on the computer.
Start Screen
Run the SG2 Client software and the below Start screen will be displayed. From this screen, you can perform the
following functions
New Ladder Program
Select File -->New -->New LAD to enter the development environment for a new Ladder program.
New FBD Program
Select File -->New -->New FBD to enter the development environment for a new FBD (Function Block Diagram)
program.
Open Existing File
Select File -->Open to choose the type of file to open (Ladder or FBD), and choose the desired program file, and
then click Open.
To Next Page
Loading...
