TECO SPEECON GS510 - Order Parameters on

42
3.7 Order Parameters O n - □ □
□ □□ □
□ □
 Order parameters are already set to the optimum value as initial values, adjustment is not
needed in the normal status.
Function
Parameter
N0.
Name LCD Display (English) Description
Factory
Setting
Control
StatusPI
On-01 Control Status 1
On-01=0000
Control Status 1
XX0X：stored the frequency reference in the
HOLD status (for up/down operation)
XX1X：Do not store the frequency reference in
the HOLD status
X0XX：PID Feedback zero input protection invalid
X1XX：PID Feedback zero input protection valid
0000
On-02 Control Status 2
On-02=0000
Control Status 2
XXX0：Inverter overload protection (OL2) valid
XXX1：Inverter overload protection (OL2) invalid
XX0X：AVR function valid
XX1X：AVR function invalid
0XXX：OL2&OL5 reset timer 5min valid
1XXX：OL2&OL5 reset timer 5min Invalid
0000
On-03 Control Status 3
On-03=0000
Control Status 3
XXX0：Anti-hunting gain change depending on
inverter output voltage
XXX1：Anti-hunting gain depending on On-07
setting
XX0X：Two-phase PWM modulation
XX1X：Three-phase PWM modulation
X0XX：Power angle compensation bias change
depending on inverter output frequency
X1XX：Power angle compensation bias fixed
0000
On-04
PID control mode
selection
On-04=0000
Reserved
XXX0：Bias D control
XXX1：Feedback D control
XX0X：PID output forward characteristics control
XX1X：PID output reversed characteristics control
X0XX：Frequency command=PID output
X1XX：Frequency command=PID output+
Frequency command
0XXX：Forward characteristics PID feedback
1XXX：Reversed characteristics PID feedback
0000
－
On-05 Not used
On-05=0
Reserved
－
0.00
On-06 Not used
On-06=0
Reserved
－
0
Hunting
Prevention
control
On-07
Hunting Prevention
gain
On-07=0.10
Hunt_Prev. Gain
Setting range：0.01 ~ 2.55
0.10
On-08
Hunting Prevention
limit
On-08=030%
Hunt_Prev. Limit
Setting range：0 ~ 100%
30% *1
Effective
current
detection
control
On-09
Effective current
detection filter time
constant
On-09=005
I_Det. Time const
Setting range：1 (3.5ms) ~ 100 (350ms)
5 *1
(17.5ms)
On-10 Not used
On-10=0
Reserved
－
0
On-delay
control
On-11 ON-DELAY TIME
On-11=011
ON-Delay Time
Setting range：
11 (2.75µs) ~ 160 (40µs), △=0.25µs
11
(2.75µs)
On-12
ON-DELAY
Compensated value
On-12=014
ON-Delay Compen.
Setting range：0 ~ 160 (40µs), △=0.25µs
14
(3.5µs)
－
On-13 Not used
On-13=0
Reserved
－
0
On-14 Not used
On-14=0
Reserved
－
0