TECO T-verter N2 Series - Communication Parameters (Fn_102); RS-485 and RS-232 Communication Setup

58
Fn_102: Communication Parameters:
xxx0: 1 stop bit
x0xx: Without parity
xxx1: 2 stop bits
x1xx: With parity
xx0x: Even parity
0xxx: 8 bits data
xx1x: Odd parity
1xxx: 7 bit data
Note:
To use RS-485 the RS-485 interface card is required.
a. For one to one control: Using a PC, PLC or some sort of control device to control one drive
set (Fn-100) to (1)
b. When controlling multiple T-verters using a PC, PLC or some sort of control device to
control multiple drives set up (Fn_100) according to the number of drives you are controlling.
Each number will identify and be used as the address for the drives identification and
parameter set-up and change.
c. There can be up to 32 T-verters that can be controlled simultaneously using the
communication interface function.
d. If the PC sends the code 33 to the T-verters, all linked T-verters (up to 32) can be controlled
simultaneously all receiving the same signal or parameter change.
To use RS-232 Communications the RS-232 interface card is required:
a. For one to one control: Using a PC, PLC or some sort of control device to control one drive
set (Fn-100) to (1)
b: An ASCII CODE is used for N2 communication.