9
9
There are two ways to place the end of drain hose:
•
• Position drain hose properly ,otherwise damage might result of water leakage.
Do not kink or protract the drain hose.
• If drain hose is too long, do not force it into washing machine as it will cause
abnormal noises.
Trough
Hose
Retainer
Bind
Min.86cm
Max.100cm
water trough
Under3m
Under 15cm
Min.86cm
100cm
Max.
1.For lower drain system
2.For upper drain system
1.Check if the legs are closely attached
the cabinet. If not, please turn them to
their original positions tighten the nuts.
2.Check alignment of the product with a
spirit level and if required, correct.
3.Loosen the lock nut and turn the feet
until it closely contacts with
to
the floor.
4.After being locked properly, press four
corners again to make
sure that they
have been adjusted properly.
• The lock nuts on all four feet must be screwed tightly against the housing.
Levelling the Washing Machine
Lock nut
foot
Raise
Lower
lockloosen
right
wrong
INSTALLATION
Caution!
Caution!
Installing the Drain Hose
1. Completely slide the drain hose over the drainage
spout.
2. Fix and tighten it with a hoop. (As shown in the figure).
The drain hose may already installed on the machine.
•
To Next Page
Loading...
