Installation Area
Before installing the machine, the location characterized
follows shall be selected:
1.Rigid, dry, and level surface
2.Avoid direct sunlight
3.Sufficient ventilation
4.Room temperature is above 0 C
5.Keep far away from the heat resources such as coal or gas.
as
Unpacking the Washing Machine
• Stability is important to prevent the product
from wandering!
• Make sure that the product is not sitting on
the power cord.
Warning!
！
•
•
Packaging material (e.g. Films, Styrofoam) can be
dangerous for children.
There is a risk of suffocation ! Keep all packaging
well away from children.
Warning!
！
8
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base
packing.
3. Remove the tape securing the power supply cord and
drain hose.
4. Remove the inlet hose from the drum.
1. Tilt or gently lay the washing machine on some soft
padding (such as a soft mat, blanket or thick towel)
on its back.
2. Insert the base cover into the grooves on the
underside of the washing machine.
(As shown in the figure).
3. Secure the base cover accordingly with screws
supplied.
• Make sure the power cord is unplugged from the mains supply.
• Assistant required for lifting.
INSTALLATION
w
w
W> 20mm
Installing the Base Cover (Option)
！
Warning!
To Next Page
Loading...
