32
Defaulting the USB Comms Path
You may want to perform a “default” for USB.
To default the USB:
1. Access the NAC panel PCB.
2. Fit test link 1 (Figure 2 on page 13, item 34) momentarily, and then
remove the link.
On-Board Memory Retention
In the absence of any power source, the on-board capacitor storage will maintain
the real-time clock and system configuration/logs for 5 days under typical
circumstances.
Programming the Network Access Controller
Refer to the TS1066 Network Access Controller Programming Manual for
detailed information about programming the Network Access Controller.
To Next Page
