SYSTEM SET CODES continued
●
CHANGING SYSTEM SET CODES Ten pages with 50 memories each.
Code 08.
To enter a system code of your choice,
●
9 KHz AM (MW) tuning rate. Code 09.
●
use the procedure below.
24 hour clock system. Code 24.
●
Rechargeable batteries to be used.
1. Turn off the radio.
Code 28.
2. Press/release the SYSTEM SET button
●
87-108 MHz FM frequency coverage.
(15). Note that '- - ' (45) appears in the
Code 87.
upper right corner of the display and
●
LW band Deactivate. Code 55.
the clock digits disappear.
3. Within 5 seconds, enter the desired
MONITORING THE CURRENT STATUS
numeric code with the numeric key pad,
OF SET CODES AND OTHER
then immediately press/release the
SETTINGS
button labeled SYSTEM SET. The code
ICON (46) will briefly appear in the
Performing a three second press of the
lower right corner of the display.
SYSTEM SET button, with the PL-450
turned off, allows monitoring of key set
DEFAULT FACTORY SYSTEM SET
codes and other settings. This information
CODES
quickly flashes in the display in the
following order.
When shipped from the factory, the radio's
1. 9 or 10 kilohertz setting
System Set Code Table is set up as
2. Rechargeable battery milliamp-hour
follows. Changes can be made via the
setting
procedure shown in the section titled
3. FM tuning range setting
CHANGING SYSTEM SET CODES.
4. Alarm’s radio frequency
8 ADDITIONAL PL-450 CONTROLS
USING THE LIGHT USING THE ANTENNA GAIN SWITCH
A quick, short press/release of the The Antenna Gain switch (20) has three
LIGHT/SNOOZE button (4), located on positions, DX, NORMAL and LOCAL. This
the front of the radio's upper right corner, switch should normally be in the DX
will turn on the display light, shining from position, providing maximum receiving
the left side of the display, for about 5 performance. If the AM or Shortwave
seconds. A longer press/release of the station that you are listening to is
button (about 3 seconds) will cause it to overwhelmingly powerful and causes
stay on indefinitely (note that this will distortion, try the NORMAL or LOCAL
decrease battery life). Turn off the light position. This switch is not used for FM
with a quick short press of the button. stations.
To Next Page
Loading...
Need help?
General
