5 CLOCK AND ALARM FEATURES
SETTING THE CLOCK CLOCK SET METHOD 3 TUNING
The factory has set the clock to function
KNOB
as a 24-hour format clock. If you prefer a 1. Turn the radio off. The clock digits
appear in the center of the display (32).
12 hour, AM/PM clock format, see the
2. Press/release the button labeled 'Time'
section titled CHANGING THE CLOCK
(10). The clock HOUR digits flash in
FROM 24 TO 12 HOUR FORMAT in the
the display.
section titled SYSTEM SET CODES.
3. Within 5 seconds, use the tuning knob
to set the hour.
There are three methods for setting the
4. Within 5 seconds, press/release the
clock.
'Time' (10) button, then use the tuning
knob to set the minute.
CLOCK SET METHOD 1 UP AND
5. Within 5 seconds of finishing,
DOWN BUTTONS:
press/release the 'Time' (10) button or
wait until the clock digits stop flashing.
1. Turn the radio off. The clock digits
appear in the center of the display (32).
You can also set the clock when you turn
2. Press/release the button labeled 'Time'
on the radio. When the radio is on, the
(10). The clock's HOUR digits flash in
clock digits appear in the upper right
the display, within 5 seconds, set the
corner of the display. Set the clock
hour using the UP/DOWN buttons
referring to the 3 methods above.
(6, 7).
3. Press/release the 'Time' (10) button
SETTING THE ALARM (USE AS WAKE-
again, the MINUTE digits flash in the
UP ALARM)
display, within 5 seconds, set the
minute using the UP/DOWN buttons
The PL-450 has a programmable alarm,
(6, 7).
enabling the PL-450 to turn on and play
4. Within 5 seconds of finishing,
press/release the 'Time' (10) button or
the radio for an alterable period of time
wait until the clock digits stop flashing.
and then turn off. The playtime can be
selected from 1 ~ 90 minutes. The alarm
CLOCK SET METHOD 2 –
can be used as a wake-up alarm. After
NUMERIC KEYPAD:
setting the alarm time and a playtime,
store a radio station into alarm memory
1. Turn the radio off. The clock digits
and activate the alarm. See the next
appear in the center of the display (32).
sections titled STORING A RADIO
2. Press/release the button labeled 'Time'
STATION INTO ALARM MEMORY and
(10). The clock's digits flash in the
ACTIVATING/DEACTIVATING THE
display.
ALARM.
3. Use the numeric keypad to key-in the
time in 24 hour format. Within 5
NOTE: A radio station must be stored into
seconds of finishing, press/release the
alarm memory. If this is not done, there
'TIME' (10) button or wait until the clock
will only be static once the timer is
digits stop flashing.
activated.
PL-450 OWNER'S MANUAL
To Next Page
Loading...
Need help?
General
