TECSYSTEM t154 User Manual

13
T154
20
HFN (NO) is displayed
The FAN1 LEDs flashes
Cyclical test of the fans for
5 minutes every "n" hours
21
Set the desired number of hours
Default NO = function
disabled
22
FCD (NO) is displayed
Fault due to quick temperature
increase (°C/sec)
23
Set the desired value
(FCD page 16)
Default "no" (function
excluded)
for version T154 (BAS) jump to the step 26
24
VOT (YES) is displayed
(See VOTING on page 19)
C01 T154 -V-
25
Set YES or NO
Default YES solo per
C01 T154 -V-
(function enable)
26
The display shows FLS (ALARM) flashing LED ALARM
(info FAIL SAFE on page 18)
27
Set YES or NO
Default NO
28
The display shows FLS (TRIP) LED flashes TRIP
29
Set YES or NO
Default NO
30
The display shows FLS (FAULT) LED flashes FAULT
31
Set YES or NO
Default YES
32
END is displayed
End of programming
33
Press ENT to store the settings and
exit programming
Err: incorrect programming of
the LED values (note 6)
34
Return to step 1
1) The MODE key allows reversing the programming steps according to the sequence 26-23-8-1.
2) The TEST key allows exiting programming without saving the modified data.
3) After 1 minute's keyboard inactivity, programming is exited without saving the data.
4) During programming the control unit does not control/protect the monitored machine.
5) At the end of programming the control unit is restarted and the FAULT relay is disabled until the unit is fully restarted.
6) If pressing ENT, “Err” appears, it means that one of the following mistakes has been made:
ERR ALL. = ALARM ≥ TRIP
ERR FAN = FAN-OFF ≥ FAN-ON. (FAN1)
The device automatically switches to the programming step of the mistake.
NOTE: EVERY TIME THE CONTROL UNIT IS PROGRAMMED WITH DATA SAVING CONFIRMATION, THE VALUES STORED IN
T-MAX ARE RESET TO THE TIME OF SAVING.

TECSYSTEM t154 Specifications

General

Brand	TECSYSTEM
Model	t154
Category	Computer Hardware
Language	English