Tectro TP 20 - STORAGE

4
61
I
S T O R A G E
Empty the internal water container (refer to Chapter F)
Clean and replace the filter.
Put the unit in air circulation mode for a couple of hours to ensure that the
inside becomes completely dry.
S t o r e cable as shown, protect the unit against dust and store in a dry place
not accessible to children.
J
TROUBLE SHOOTING
Never try to repair or dismantle the air conditioner yourself. Incompetent re p a i r s
result in loss of warranty and can endanger the user.
Problem Cause Solution
No power supply
Connect to a functioning outlet
and switch on
Water tank indicator is on
Empty the internal water
container (refer to Chapter F)
In direct sunlight Close curtains
Windows or doors open, many
people or heat source in room
Close doors and windows, or
place an extra air conditioner
Dirty filter Clean or replace filter
Air inlet or air outlet blocked Remove blockage
Room temperature lower than
selected value
Change temperature selection
The unit is noisy Unit stands uneven
Place on even surface (less
vibrations)
The compressor
does not work
Overheat protection probably
activated
Wait 3 minutes until the
temperature has decreased, and
turn on the unit again
Distance too great
Remote control signal not
detected by control panel
Batteries empty Replace the batteries
The unit does
not seem to
perform
The unit does
not function
Remote control
does not
function
Make sure the remote control is
correctly aimed at the control
panel