3. Set the starting & stopping time
3.1
Push the Timer on button i, the remote controller display will show ON TIMER, the last set time for
Timer on operation in hours will be shown on the Timer display area. You are now ready to readjust
the
Timer on to start the operation.
3.2
Push the Timer on button i again to set the time you want to start the operation.
3.3
Push the Timer off button j, the remote controller will show OFF TIMER, the last set time for STOP
operation and the signal "Hr" will be shown on the Timer display area. You are now ready to set the
time to STOP operation.
3.4
Push the Timer off button j again to set the time you want to stop the operation.
3.5
After setting the TIMER, there will be half a second delay before the remote controller transmits the
signal to the Air Conditioner. Then, after approximately another 2 seconds, the signal "h" disappears
and the set temperature will re-appear on the digital display.
F OPTIMAL OPERATION
To achieve optimal performance, please note the following:
•
Adjust the air flow direction correctly so that it is not directly directed to people.
• Adjust the temperature to achieve the highest comfort level. Do not adjust the unit to excessive tem-
perature levels.
• Close doors and windows otherwise the desired effect may be reduced.
•
Use TIMER ON button on the remote controller to select a time you want to start your air conditioner
.
• Do not put any object near air inlet or air outlet, as the efficiency of the air conditioner may be redu-
ced and the air conditioner may stop running. Make sure there are no obstacles blocking the airflow.
The air stream must be allowed to reach the entire room unhindered. Also the air stream must be allo-
wed to reach the air conditioner unhindered.
• Clean the air filter periodically, otherwise cooling or heating performance may be reduced. It is advi-
sed to clean the filters every two weeks.
•
Do not operate unit with horizontal louvre in closed position.
G
WARNING
• Keep the Remote Controller away from all liquids.
• Protect the Remote Controller from high temperatures and exposure to radiation.
• Keep the indoor receiver out of direct sunlight or the Air Conditioner may malfunction.
•
Never mix new and old batteries. Never use dif
ferent battery types (e.g. alkaline and
manganese dioxide) simultaneously.
G
NOTE!
• If the same time is set for both START and STOPPING settings, the stopping time will
automatically increase 0.5hr(the set time displays less than 10Hr) or one hour (the set time
displays 10Hr or more).
• To change the Timer on/off time, just press the corresponding TIMER button and reset the
time.
• The setting time is relative time. That is the time set is based on the delay of the current time.
4
112
man_TS1xx_uk.qxd 10-05-2007 14:13 Pagina 112
To Next Page
Loading...
Need help?
General
