The FitSpine Heat & Vibration Comfort Cushion is
compatible with Teeter FitSpine X and LX Series model
inversion tables.
Locate the included Attachment Nodes and unscrew
the backing from each.
Figure 1: Place the cushion onto the Table Bed aligned
with the designated holes.
Figure 2: Insert a node backing from the back of the
Table Bed through the Table Bed slot and hole in the
cushion. Hold the backing perpendicular to the slot.
Figure 3a & 3b: With the other hand, fasten the
node top onto the backing threads visible from the
front of the Table Bed. Twist the node clockwise to
secure it into place in one of two ways:
1. Static: If you do not want the cushion to move
with you as you invert, tighten the node until it is
snug. Do not over-tighten.
2. Responsive: If you want the cushion to slide
with you as you invert to encourage body slide at
shallower angles, tighten the node just tight enough
to keep it in place, but loose enough to move within
the slot.
Repeat the process above with the three (3)
remaining fastening nodes to finish securing the
cushion to the Table Bed.
Be sure to replace the backings onto the nodes when
the cushion is removed.
ATTACH CUSHION TO TABLE BED
STEP 1
Figure 1
Figure 2
Figure 3a Figure 3b
4
To Next Page
Loading...
