Before attaching the cushion to the Power Adapter,
ensure the inversion table is located close enough to
the power source so the cable will reach.
Figure 4: Connect the Power Adapter to the cushion.
Figure 6: Connect the Power Adapter to a 120 volt
AC outlet.
Figure 5: Locate the two hook and loop straps that
come pre-attached to the Power Adapter cable.
Use these straps to secure the cable to the table
bed so that the cable does not interfere with the
operation of the inversion table.
CONNECT POWER ADAPTER
STEP 2
Figure 4
Figure 6
Figure 5
5
Be certain that the cable is AWAY and CLEAR of the
inversion table pivot points. Test the operation of
the table by moving the table bed into the inverted
position with your hands before attempting to invert
to ensure the cable will not be pinched while in use.
ALWAYS disconnect the cushion from the power
source when not in use.
WARNING
WARNING
!
!
To Next Page
Loading...
