Teison TS-EVC07-003(S) - Solar Mode Charging

To Next Page

To Previous Page

Solar Mode:

To use the Solar mode, you need to install the CT Meter and connect it to the

same Wi-Fi network as the EV charger. For detailed instructions, please refer to

the CT Clamp manual.

Solar Mode: Activating this option means that the charger will only work with

solar power.

Solar current limit: You can set the minimum remaining current in the solar

system to 7A using the Solar current limit. Then, the charger will work.

Boost Mode: You can turn on the Boost Mode to prioritize the use of solar

energy. When there isn't enough solar energy, power from the grid will be

withdrawn at the same time.

Solar Mode period: You need to manually set the Solar Mode period. During this

time range only, the solar mode will be active.

Attention: It's important to note that the charge using solar will only

start if the surpluses are equal to or more than the solar current limit

and if the charge time is within the solar mode period time.