● Undo the cylindrical nut. This is located at
the base of the filter cartridge. When doing
this, do not grip the cylindrical nut directly
with your hands but from outside through the
bag.
● Place the filter cartridge upright again.
Remove the cylindrical nut from the bag.
● Remove the displacer from the filter
cartridge.
● Seal the disposal bag (e.g. with cable ties).
The operator is obliged to store and
dispose of contaminated filter
cartridges in accordance with
national or regional regulations.
● First of all, remove all the filter cartridges as described in the steps above.
● Only then should you start to install the new filter cartridges.
Only use TEKA replacement filters. Otherwise the correct functioning of the unit
is not guaranteed.
BA_FilterCube_4_IFA_20230808_EN
To Next Page
Loading...
