Teka TR 620 - The Clock as Countdown

When more than one cooking area is
being timed simultaneously the time indi-
cator will, by default, show the cooking
time remaining in the area that will discon-
nect first. If you wish to check the cooking
time remaining in another area, touch the
area's selection sensor - for a few seconds
the indicator will show the remaining coo-
king time for that area.
Changing the programmed time
The time that you have set can be chan-
ged subsequently, if you so wish.
1 The hotplate being timed must have alre-
ady been selected. The corresponding
decimal point (13) has to be lit.
2 Touch the clock sensor (7). The deci-
mal point (13) will come on.
3 Use the or sensors (7/4) to alter
the time.
Disconnecting the clock
If you wish to stop the clock before the pro-
grammed time has elapsed:
1 The hotplate being timed must have alre-
ady been selected. The corresponding
decimal point (13) has to be lit.
2 Select the clock sensor (7). The deci-
mal point (13) will come on.
3 Use sensor (4) to reduce the time
down to 00. The clock is cancelled but
the hotplate will continue to be active
until you switch it off.
Switching off rapidly
1 The hotplate being timed must have alre-
ady been selected. The corresponding
decimal point (13) has to be lit.
2 Select the counter sensor (7). The
corresponding decimal point (13) has to
be lit.
3 Touching the and sensors (7 and
4) simultaneously cancels the remaining
time.
You can also turn off the hotplate being
timed without the programmed time having
elapsed. In this case, the timer will switch
off too.
The Clock as a Countdown
Counter (models VT TC 60 PH,
TR 640, TT 640, TZ 640, TC 620
and TR 735 AB)
Whenever the clock is not being used with
a cooking area, it can be used as a coun-
ter. To do this, you use the clock without
selecting an area
CONNECTING THE COUNTER
When the appliance is switched off.
1 Touch the On sensor (1).
2 Before using any hotplate, touch the
clock sensor or (7). All the control
indicators (11) are switched off.
3 Use the sensors or (5/4) to input
the time you want, or use the sensors
or (7/4) on TC 620 model.
When the programmed time elapses, a
series of beeps will sound for several
seconds. To switch these beeps off, touch
the sensor or (7).
DISCONNECTING THE COUNTER
If you wish to stop the counter before the
programmed time has elapsed:
GB
30