© 2016 680_D - 05/16 30 of 48
Monitor Menu (1 of 3)
Description Range Access
MELTING ENERGY
Records the amount of energy used by the snow melting system since the counter was last
reset.
Conditions: Always available.
Hydronic
0 to 999999
thm or GJ
Electric
0 to 999999 kWh
User
Installer
MELTING HOURS
Records the number of melting hours since the counter was last reset.
Conditions: Always available.
0 to 999999
hours
User
Installer
HEAT HOURS
Records the number of hours the boiler fired or the electric cable heated since the counter
was last reset.
Conditions: Always available.
0 to 999999
hours
User
Installer
HEAT CYCLES
Records the number of cycles the boiler turned on or the electric cable heated since the
counter was last reset.
Conditions: Always available.
0 to 999999
cycles
Installer
SYSTEM PUMP
Records the number of hours the system pump has operated since the counter was last
reset.
Conditions: Available when Application Mode is not set to Electric.
0 to 999999
hours
Installer
PRIMARY PUMP
Records the number of hours the primary pump has operated since the counter was last
reset.
Conditions: Available when Application Mode is not set to Electric.
0 to 999999
hours
Installer
BOILER PUMP
Records the number of hours the boiler pump has operated since the counter was last
reset.
Conditions: Available when Application Mode is set to Boiler or Boiler+Mix.
0 to 999999
hours
Installer
SLAB SENSOR 1 HIGH
Records the highest measured slab 1 temperature since the counter was last reset.
Conditions: Available when Snow/Ice Sensor 1 is set to In-slab or Slab Sensor 1 = On.
-58 to 167°F
(-50.0 to 75.0°C)
Installer
SLAB SENSOR 1 LOW
Records the lowest measured slab 1 temperature since the counter was last reset.
Conditions: Available when Snow/Ice Sensor 1 is set to In-slab or Slab Sensor 1 = On.
-58 to 167°F
(-50.0 to 75.0°C)
Installer
SLAB SENSOR 2 HIGH
Records the highest measured slab 2 temperature since the counter was last reset.
Conditions: Available when Snow/Ice Sensor 2 is set to In-slab or Slab Sensor 2 = On.
-58 to 167°F
(-50.0 to 75.0°C)
Installer
SLAB SENSOR 2 LOW
Records the lowest measured slab 2 temperature since the counter was last reset.
Conditions: Available when Snow/Ice Sensor 2 is set to In-slab or Slab Sensor 2 = On.
-58 to 167°F
(-50.0 to 75.0°C)
Installer
To Next Page
Loading...