Need help?Do you have a question about the Teknatool NOVA Comet II and is the answer not in the manual?
Details on the 3-step electronic variable speed ranges.
Instructions for assembling the tailstock and its components.
Details on the DC motor and its brush run-in procedure.
Explanation of pulley selection for different speed ranges.
How to lock and unlock the spindle using the index pin.
Guide for installing faceplates or chucks onto the spindle.
How to move the tailstock and operate the quill.
Procedure for setting up the tailstock for between-center turning.
Instructions for mounting and using the drive spur center.
Common causes and solutions for lathe vibration.
How to fix issues with unbalanced faceplates or chucks.
Ensuring correct alignment between tailstock and headstock centers.
Steps to diagnose and fix a motor that fails to start.
To Next Page
General
