______________________________________________________________________________ Page 25 of 31
Tekron International Ltd PO Box 31 285 Lower Hutt 6009 New Zealand
tel: +64 4 566 7722 fax: +64 4 569 9272
email: support@tekroninternational.com
7 Factory Hardware / Firmware Options
7.1 Opt. 1 – NTS01E Extension unit.
This unit (where fitted) provides up to three further Network Time Server Ethernet ports, (NTS3,
NTS4 and NTS5) each with the same function and feature set as ports NTS1 and NTS2. If this
option is specified, the Multiport option (Opt 5) can
not be included.
7.2 Opt. 2L, Opt. 2M, Opt. 2H - Power Supply Options
There are three different power supply configurations that may be ordered with TCG 01.
a) Order
Opt.2L Nominal 24Vdc
This supply operates with DC input in the range 12 –36Vdc,
or with AC input in the range 16-24Vac
b) Order
Opt.2M Nominal 48Vdc
This supply operates with DC input in the range 20-72Vdc,
or with AC input in the range 24-48Vac
c) Order
Opt .2H Nominal 110/250Vdc
This supply operates with DC input in the range 90-350Vdc,
or with AC input in the range 80-240Vac
7.3 Opt. 3 - Local Time Display / Output
This factory firmware option provides for display of local time on the front panel of NTS01 and
also allows local time to be output on the P5 (IRIG-B) output for use in synchronising other
vendors’ equipment if required. See NTS01 configuration – Section .. for details on setting the
local time and daylight savings parameters. Note: Other NTS01 units configured for Slave
operation that use the P5 signal for synching purposes, will
always correctly interpret this signal,
regardless of the local time setting.
7.4 Opt. 4 - Lightning Protection Kit
A lightning Protection kit is available for fitting into the antenna lead-in cable. The kit contains a
protection device, two coaxial cable connectors, a connector crimp tool, and mounting hardware
for the protection device. Full instructions relating to the installation and maintenance of the
lightning protector are included with the kit, together with some guidelines as to best positioning
of the antenna and protector unit to minimize the possibility of lightning-induced damage to the
TCG 01 base unit.
To Next Page
Loading...