Tekron NTS 01 - NTS01 Certification and Testing Standards

NTS 01 Rev 1
–
User Manual March 2006
______________________________________________________________________________ Page 26 of 31
Tekron International Ltd PO Box 31 285 Lower Hutt 6009 New Zealand
tel: +64 4 566 7722 fax: +64 4 569 9272
email: support@tekroninternational.com
8 Certification & Testing
Tekron products are CE certified and comply with the following international standards:

IEC 61000-4-2:1995
Electromagnetic Compatibility (EMC) Part 4: Testing and measurement techniques
Section 2: Electromagnetic discharge immunity test

IEC 61000-4-3:2002
Electromagnetic Compatibility (EMC) Part 4: Testing and measurement techniques
Section 3: Radiated, radio frequency, electromagnetic field immunity test

IEC 61000-4-4:1995
Electromagnetic Compatibility (EMC) Part 4: Testing and measurement techniques
Section 4: Electrical fast transient burst immunity test.

IEC 61000-4-5:1995
Electromagnetic Compatibility (EMC) Part 4: Testing and measurement techniques
Section 5: Surge immunity test.

IEC 61000-4-6:2003
Electromagnetic Compatibility (EMC) Part 4: Testing and measurement techniques
Section 6: Immunity to conducted disturbances, induced by radio frequency fields.

IEC 61010-1:2001
Safety requirements for electrical equipment for measurement, control and laboratory
use - Part 1 General Requirements.

IEC 61326:2002
Electrical equipment for measurement, control and laboratory use - EMC requirements.

CISPR 22:2003
Information technology equipment - Radio disturbance characteristics - limits and methods
of measurement.

FCC 47 Part 15:2002
RF emission requirements of the Federal Communications Commission