Tektronix MDO34 Declassification And Security Instructions

Clear or sanitize a non-functional instrument
Use the following procedures to clear or sanitize a non-functional instrument.
Acquisition board
Only qualified personnel should perform service procedures. Read the General
Safety Summary and the Service Safety Summary in the 3-Series MDO Service
Manual (Tektronix part number, 077-1500-xx) before performing any service
procedures.
Remove the Acquisition board and return the product to Tektronix. A new
Acquisition board will be installed and the instrument will be repaired and
adjusted as necessary.
For removal instructions, refer to the service manual available on the Tektronix
Web site at www.tektronix.com/manuals.
After removing the Acquisition board, refer to your company's internal policies
regarding handling or disposal of the board.
USB flash drive
Remove the USB flash drive and return the instrument to Tektronix for repair.
After removing the USB flash drive, refer to your company's internal policies
regarding handling or disposal of the flash drive.
Charges
Replacement of any missing hardware will be charged according to the rate at the
time of replacement.
3 Series MDO Declassification and Security Instructions 13

Tektronix MDO34 Specifications

General

Analog Channels	4
Sample Rate	2.5 GS/s
Record Length	10 Mpoints
Mixed Domain Analysis	Yes
Waveform Capture Rate	>280, 000 wfms/s
Spectrum Analyzer Frequency Range	9 kHz to 3 GHz
Vertical Resolution	8 bits
Input Coupling	AC, DC, GND
Operating Temperature	0°C to +50°C
Digital Channels	16
Connectivity	USB, LAN, HDMI
Arbitrary Function Generator	50 MHz
Trigger Types	Edge, Pulse Width, Runt, Logic, Setup/Hold, Rise/Fall Time, Video
Input Impedance	1 MΩ
Maximum Input Voltage	300 Vrms
Dimensions	140 mm
Weight	4.5 kg
Bandwidth	100 MHz, 200 MHz, 350 MHz, 500 MHz
Display	10.1-inch capacitive touch HD display
Voltmeter	4-digit