Giving Demos of Advanced Tektronix 4000 Features
The following are general demo procedures that cover the key points of Wave Inspector and Serial Triggering and Analysis.
Demo IX: Setting Up I2C Signals
1. Connect th e ground lead of a P613 9A
probe to a point labeled GND on the demo
board.
Connect the P6139A probe from channel 1
on the oscillos cope to the SC LK test point
on the demo board.
2. Connect the ground lead of a second
P6139A probe to a point labeled GND on
the demo board.
Connect the second P6139A probe from
channel 2 on the oscilloscope to the I2C
SDA test point on the demo board.
Tektronix 4000 Oscilloscope Demo In struction Manual 23
To Next Page
Loading...
