Need help?Do you have a question about the Tektronix TAS 250 and is the answer not in the manual?
General| Bandwidth | 50 MHz |
|---|---|
| Number of Channels | 2 |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Display | CRT |
| Power Supply | 100-240 V AC, 48-440 Hz |
| Input Impedance | 1 MΩ |
| Sampling Rate | N/A (Analog Oscilloscope) |
| Trigger Modes | Auto, Normal |
Lists required test equipment for performance verification procedures.
Details the initial settings for oscilloscope performance verification.
Procedures to verify the vertical accuracy of the oscilloscope.
Procedures to verify the horizontal accuracy of the oscilloscope.
Verifies the trigger accuracy of the oscilloscope.
Verifies the cursor accuracy of the oscilloscope.
Lists all adjustments for TAS 220 and TAS 250 oscilloscopes.
Lists required test equipment for performing adjustment procedures.
Provides guidelines for preparing the instrument for adjustment procedures.
Instructions on how to remove the instrument cover for internal adjustments.
Lists the initial settings to preset the oscilloscope before adjustments.
Procedures to adjust the power supply voltages of the instrument.
Procedures to adjust various vertical parameters of the oscilloscope.
Procedures to adjust various horizontal parameters of the oscilloscope.
Procedures to adjust the trigger settings of the oscilloscope.
Procedure to adjust the probe compensation for accurate measurements.
Procedures to adjust cursor accuracy and minimize readout drift.
To Next Page
