Need help?Do you have a question about the Tektronix TBS1102 and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 1 GS/s |
| Display | 7-inch TFT color display |
| Vertical Resolution | 8 bits |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Timebase Range | 5 ns/div to 100 s/div |
| Display Type | TFT LCD |
| Connectivity | USB 2.0 |
| Dimensions | 12.5 in x 5.8 in x 6.5 in |
| Weight | 3.2 kg |
| Display Resolution | 800 x 480 |
| Trigger Modes | Edge, Pulse Width |
| Trigger Types | Edge, Pulse, Video |
| Power Supply | 100 to 240 V ±10%, 45 Hz to 66 Hz |
| Input Impedance | 1 MΩ ± 2% in parallel with 20 pF ± 3 pF |
Details specifications for the signal acquisition system.
Specifies characteristics of the time base system.
Lists specifications for the triggering system.
Outlines general conditions and specific tests for verifying performance.
Outlines the step-by-step process for adjusting calibration constants.
Guidelines to prevent damage from electrostatic discharge during servicing.
Step-by-step instructions for removing and installing various oscilloscope modules.
A flowchart to help isolate problems by guiding through diagnostic steps.
Steps to diagnose power supply module issues by checking voltages.
Procedure to diagnose and resolve issues with a non-functional display.
Steps to diagnose problems with the oscilloscope's front panel controls.
Diagnosing issues with the main board by checking power supply voltages.
To Next Page