Need help?Do you have a question about the Tektronix TBS1102B and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 1 GS/s |
| Record Length | 2.5 kpts |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Vertical Resolution | 8 bits |
| Timebase Range | 5 ns/div to 50 s/div |
| Display Type | TFT LCD |
| Display Resolution | 480 x 234 pixels |
| Display | 7-inch TFT LCD |
| Max Input Voltage | 300 VRMS, CAT II |
| Trigger Types | Edge, Pulse, Video |
| Interfaces | USB 2.0 |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Input Impedance | 1 MΩ ±2%, 13 pF ±3 pF |
Covers general safety, fire/injury avoidance, and product usage guidelines.
Safety guidelines for using probes and test leads, including voltage warnings.
Safety precautions for personnel performing maintenance and repair on the product.
Overview of oscilloscope features and instructions for initial setup and installation.
Procedures for functional checks, probe compensation, and attenuation settings.
Instructions for updating the oscilloscope's firmware via internet or USB.
Explanation of display elements, message area, and menu system navigation.
Guide to using vertical, horizontal, and trigger controls for waveform management.
Covers oscilloscope setup functions like Autoset, Autorange, and basic triggering concepts.
Explanation of signal acquisition modes, time base, scaling, positioning, and aliasing.
Methods for taking measurements using graticules, cursors, and automatic functions.
Details on the USB flash drive port for data storage and retrieval.
Instructions for connecting the oscilloscope to a PC via USB or a GPIB system.
To Next Page
