Removal and Installation Procedures
TDS 500B, 600B and TDS 700A Service Manual
6–11
tool whenever a procedure step instructs you to remove or install a screw unless
a different size screwdriver is specified in that step. All equipment required to
remove and reinstall each module is listed in the first step of its procedure.
Table 6–4: Tools Required for Module Removal
Item
No.
Name Description
Tektronix Part
Number
1 Screwdriver handle Accepts TorxR-driver bits 003-0301-00
2 T-15 Torx tip TorxR-driver bit for T-15 size screw
heads
003-0966-00
3 T-20 Torx tip TorxR-driver bit for T-20 size screw
heads
003-0866-00
4 T-20 Torx tip Special Tool: Narrow TorxR-driver
bit for T-20 size screw heads (fan
removal only)
003-1457-01
5 Flat-bladed screwdriver Screwdriver for removing standard-
headed screws
6 Needle-Nose Pliers Standard tool
7 Nutdriver,
1
@
4
inch Standard tool
8 Retaining Ring Pliers Standard tool; 1
1
@
8
inch minimum
throw
9 Angle-Tip Tweezers Standard tool
10 Soldering Iron Standard tool
11 Pliers Standard tool
12 Solder Wick Standard tool
13
8
@
32
hex tip Bit for
8
@
32
hex set screw
14 Adhesive TRA-CON: Tra-Bond #BA-2114
To Next Page
Loading...
