Removal and Installation Procedures
TDS 500B, 600B and TDS 700A Service Manual
6–35
1
2
3
To J1500
Coax Cable
Figure 6–15: Circuit Board Removal
4. Reinstallation:
a. Do, in reverse order, steps a through e. Reverse the removal instructions
of each step to reinstall the A29 Video Trigger Board.
NOTE. For the TDS 600B, be sure to arrange the coax cable as shown in Figures
6–14 and 6–15. Failure to do this may impair performance.
Also, when plugging in the digital bus boards, 1 and 3 in Figure 6–15, make
sure that they remain plugged in on both ends.
To Next Page
Loading...
