connector closes. When closed
and properly seated, the top of
connector will be flush with the
probe tip housing.
Probe comp box controls and indicators
Input mode buttons and LEDs
The P7700 TDP7700 Series solder-in tips support TriMode operation. TriMode enables you to switch the probe between
four different measurement types without changing the probe’s connection:
Press the Input Mode button to
select one of the four TriMode
measurements. The modes cycle
in the following sequence:
Note: You can also change the Input Mode in the oscilloscope Probe Setup
panel.
Installation
P7700 Series TriMode™ Probes 7
To Next Page
Loading...
