(b) To avoid any interference during remote setting, place the
transmitter to RX as close as possible.
(c) Turn off the RX power completely (MAIN SWITCH) for 20
seconds and turn it on again.
(d) Complete the remote setting within 4 minutes after turning on the
RX. The RX will NOT accept the remote setting signal after 4
minutes.
Instruction:
1. Depress the TX Emergency Stop or remove the magnetic key (for
F21-E1B/4SB without a Mushroom style stop button that stays
depressed, please hold down the STOP pushbutton)
2. Press UP pushbutton and hold it.
3. Press DOWN pushbutton 4 times and release “STOP & UP”
pushbutton when red LED flash.
4. Start the system as usual.
Note:
(1) By following the procedures above, all radios of same model within
its radio operating distance might be affecting by ID code remote
setting.
(2) ID code remote setting only transmits data of ID code only.
(3) Receiver will not accept ID code remote setting signal 4 minutes after
main power being turned ON.
26
To Previous Page
Loading...
Need help?
General
